Automotive Fuel leakage Diagnostic Tester
Automotive Fuel leakage Diagnostic Tester 2 MODES Car Conduit PIPE System Leakage Tester Car Fuel Leak Detector For 12V Vehicle Boat With Adjustable FlowMeter EVAP Leak Testers Detectors
This machine have 2 modes( AIR Mode and SMOKE mode) detect the leakage of pipe systems on cars, motorcycles, boats...such as fuel pipe, air intake system and cooling tank.
The machine will change special oil into smoke, then blow smoke into sealed pipe system. you will find leak point in pipe via the smoke.
This upgraded machine now can work on EVAP system (pressure of machine was larger than EVAP request )
Inbuilt air compressor,Instant smoke generation. Self-protective system will keep machine away from overload. Combine with adjustable flowmeter and pressure guage,we can adjust output of smoke ,then check leakage level via smoke flow variety
This machine can show Flow Gauge and Liquidometer Gauge.Input :12V DC ; Smoke output value: 6L/min,
Automotive Fuel leakage Diagnostic
Operation
1.Open the engine cover, and hang the detector in the cover.
2.Disconnect the pipe that needs to be connected with detector. If the pipe needs to be disconnected in the middle. Please secure the other side with a rubber stopple.
3.Secure this side with proper taper stopple/pipe, and connect it with smoke output tube.
4.Connect detector with DC12V battery: red with positive, black with negative. Do not connect in a contrary way.
5.Turn on the power switch, and detector starts to work.
6.Adjust the flow gauge. Control the input smoke value and pressure to make sure the pipe system can afford the pressure.
7.In about 3 minutes, the pipe will be filled with smoke.
8.Observe the floating ball in flow gauge. If the floating ball stays still in the bottom, the pipe is sealed with. If the floating ball is arising or bouncing, the pipe is leaking.
9.Position the leak points by floating ball. If the bounce arises highly, the leakage is serious.
10.Check the leak points. Please use head lamp if necessary.
11.After leak detection, please connect well the wires and pipe.
Do not run the detector over 5 minutes. It needs interval rest.
The detector has protector. If it exceeds working limit, it will power off automatically. In this condition, please operate it later.